A number of controls allow pilots to direct aircraft in the air. The controls found in a typical fixed-wing aircraft are as follows:
* A yoke or joystick, which controls rotation of the aircraft about the pitch and roll axes. A yoke resembles a kind of steering wheel, and a control stick is just a simple rod with a handgrip. The pilot can pitch the aircraft downward by pushing on the yoke or stick, and pitch the aircraft upward by pulling on it. Rolling the aircraft is accomplished by turning the yoke in the direction of the desired roll, or by tilting the control stick in that direction. Pitch changes are used to adjust the altitude and speed of the aircraft; roll changes are used to make the aircraft turn. Control sticks and yokes are usually positioned between the pilot's legs; however, a sidestick is a type of control stick that is positioned on either side of the pilot (usually the left side for the pilot in the left seat, and vice versa, if there are two pilot seats).
* Rudder pedals, which control rotation of the aircraft about the yaw axis. There are two pedals that pivot so that when one is pressed forward the other moves backward, and vice versa. The pilot presses on the right rudder pedal to make the aircraft yaw to the right, and on the left pedal to make it yaw to the left. The rudder is used mainly to balance the aircraft in turns, or to compensate for winds or other effects that tend to turn the aircraft about the yaw axis.
* A throttle, which adjusts the thrust produced by the aircraft's engines. The pilot uses the throttle to increase or decrease the speed of the aircraft, and to adjust the aircraft's altitude (higher speeds cause the aircraft to climb, lower speeds cause it to descend). In some aircraft the throttle is a single lever that controls thrust; in others, adjusting the throttle means adjusting a number of different engine controls simultaneously. Aircraft with multiple engines usually have individual throttle controls for each engine.
* Brakes, used to slow and stop the aircraft on the ground, and sometimes for turns on the ground.
Other possible controls include:
* Flap levers, which are used to control the position of flaps on the wings.
* Spoiler levers, which are used to control the position of spoilers on the wings, and to arm their automatic deployment in aircraft designed to deploy them upon landing.
* Trim controls, which usually take the form of knobs or wheels and are used to adjust pitch, roll, or yaw trim.
* A tiller, a small wheel or lever used to steer the aircraft on the ground (in conjunction with or instead of the rudder pedals).
* A parking brake, used to prevent the aircraft from rolling when it is parked on the ground.
The controls may allow full or partial automation of flight, such as an autopilot, a wing leveler, or a flight management system. Pilots adjust these controls to select a specific attitude or mode of flight, and then the associated automation maintains that attitude or mode until the pilot disables the automation or changes the settings. In general, the larger and/or more complex the aircraft, the greater the amount of automation available to pilots.
Control duplication
On an aircraft with a pilot and copilot, or instructor and trainee, the aircraft is made capable of control without the crew changing seats. The most common arrangement is two complete sets of controls, one for each of two pilots sitting side by side, but in some aircraft (military fighter aircraft, some taildraggers and aerobatic aircraft) the dual sets of controls are arranged one in front of the other. A few of the less important controls may not be present in both positions, and one position is usually intended for the pilot in command (e.g., the left “captain's seat” in jet airliners). Some small aircraft use controls that can be moved from one position to another, such as a single yoke that can be swung into position in front of either the left-seat pilot or the right-seat pilot.
Aircraft that require more than one pilot usually have controls intended to suit each pilot position, but still with sufficient duplication so that all pilots can fly the aircraft alone in an emergency. For example, in jet airliners, the controls on the left (captain's) side include both the basic controls and those normally manipulated by the pilot in command, such as the tiller, whereas those of the right (first officer's) side include the basic controls again and those normally manipulated by the copilot, such as flap levers. The unduplicated controls that are required for flight are positioned so that they can be reached by either pilot, but they are often designed to be more convenient to the pilot who manipulates them under normal condition.
Sunday, February 17, 2008
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment